Natural Stone Sealer Enhancer

Applicable to those requiring a permanent enhanced “wet look” sealer without a topical film.

Rejuvenates Worn and Weathered Stone With The Added Benefit Of Stain Protection!

Wet Look formulated sealer designed to darken and highlight the character of natural stone!

• Resistance to water, oil borne contaminates and staining.
• Protects against food and beverage stains, oil & greasy spills.
• Protects against mould & mildew, pollution and weathering.
• Reduces the occurrence of efflorescence.
• Produces enhancing effect without artificial film.
• Breathable, won’t trap moisture.

• Deep penetrating.
• Forms sub-surface repellent shield.
• Additional coats enable greater colour enhancement.
• Non film forming will not flake or peel.
• Can be applied by:

 

1 Drum
$169 each

Buy Now

1 Drum
$359 each

Buy Now

2 Drums
$339 each

Buy Now

3 Drums or more
$329 each

Buy Now

While we provide both water and solvent based products, the ultra deep rich enhancement achieved by this product can only be achieved by full solvents!
Water based or even semi-solvent products simply do not provide the same level of intensity!

Suitable for: Sandstone, Limestone, Terracotta, Granite, Travertine, Slate, Marble, Quartz, Bluestone and Masonry

Our Penetrating Natural Stone Sealer Enhancer…

…is simply not a painting process or stain. Rather, enhancing natural stone draws out the characteristics or personality of the original stone! This is also true for stone involving an irregular combination of colours or that have experienced fading.

Application Directions:

· Protect any adjacent areas by masking to avoid splashes or over-spray onto surfaces not intended to be treated. · The surface must be clean. · Apply liberal coating. · Leave the sealer to penetrate the surface for 5-10 minutes. Required colour is dependent on porosity of the surface, drying time and penetration. · Wipe off excess with clean cloth or polishing machine prior to fully drying. · Do not allow excess to fully dry on the surface as it may result in a residue that will need to be mechanically or chemically removed. · Repeat the process for a greater depth of colour enhancement. No more than 3 coats are to be applied.

 Technical  Description
 Application  Broom, Brush, Roller or Spray
 Coats  Minimum 2 Coats (for greater enhancement an additional coat may be applied)
 Coverage  150-300 sq.ft / gallon per coat on porous surfaces 
 N/A on non-porous surfaces 
 Dry Time  Touch Dry: 2 Hours
 Re-coat: 5-20 mins 
 Light Traffic: 2 – 6 Hours
 Heavy Traffic: 24- 48 Hours
 Wash Up  Clean-up immediately on completion.
 Limitations  Light colored substrates. May require additional coats.
 Recommended Uses  Internal or External: All sandstone, limestone, granite, travertine, slate, porcelain, marble & masonry surfaces.